# Tutorial - Dell Sonic Enterprise and Dell servers in a spine-leaf configuration

This tutorial walks you through the steps required to register and use a setup that uses the following physical configuration:
1. 3 x Dell Enterprise SONiC 4.0.2
2. 2 x Dell R250 servers  

![](/assets/guides/deploying-metalsoft-using-ovas-01.svg)

This tutorial also assumes you have completed the configuration part of MetalSoft. Follow the [Deploying MetalSoft using OVAs](/content/overview/installation/deploying_metalsoft_using_OVAs) for more details on how to configure deploy MetalSoft.

## Cabling

```
# management links 

ESXi server, port 01 <---> OOB switch, port 15

leaf01, port MGMT <---> OOB switch, port 01
leaf02, port MGMT <---> OOB switch, port02
spine01, port MGMT <---> OOB switch, port03

#spine-leaf links
leaf01, port 11 <---> spine01, port 01
leaf02, port 11 <---> spine01, port 02

# server links leaf1
leaf01, port 01 <---> server01, port01
leaf01, port 02 <---> server01, port02

leaf01, port 03 <---> server02, port01
leaf01, port 04 <---> server02, port02


# server management ports
server01, port iDRAC <---> OOB switch, port 11
server02, port iDRAC <---> OOB switch, port 12
```


## Registering switches

Pre-requisites:
1. Deploy Dell Enterprise Sonic 4.x on the switches
2. Configure a management IP reachable from the Site Controller
3. RESTCONF is enabled on the switch
4. The BGP underlay configuration is done between the switches.

> Note that MetalSoft can provision servers via ZTP but tht process is not covered in this tutorial. 

To register the 3 switches, for each switch go to **Switches** > **Add Switch**

1. From the `Driver` dropbox select `sonic_enterprise`
2. From the `Switch role` dropbox select `Leaf` for leaf switches other for spine
3. From the `Management protocol` dropbox select `RESTCONF`
4. From the `Management address` textbox input the IP of the  switch management port
5. From the `Management username` textbox input the username of the switch
6. From the `Management password` textbox input the password of the switch

All other fields can stay the same.

At the end of the process the switches should all show as `Active`. 
> Note that it is normal for them not to show any network connections as those will be populated as we add servers.


## Registering servers
Pre-requisites:
1. The servers have an IP on the iDRAC interface reachable from the agent VM.

To register the 2 servers go to **Servers** > **Add Server**

1. Select Vendor Dell
2. Select Type Server
3. IPMI Host -> input the ip of the server
4. IPMI username -> input the IPMI username
5. IPMI password -> input the IPMI password
6. Click Add Server

> Note that the IPMI protocol should not necessarily be activated as this mechanism uses Redfish instead.

This process can take up to 30 min depending on the type of drives and NICs.

At the end of this process you should be able to use the servers in the infrastructure editor as usual.

For more information consult:
Consult the following for more information:
* [Managing switches](/content/configuration/network/managing_switches)
* [Managing servers](/content/configuration/servers/adding_a_new_server)